Chevron techron SUCKs!

[zen_master]

i think you should use this BG thingie....and do what it says on the can/tin... and then, do a road trip....about 400 miles with 80 mph for few hours....with cruise control, of coarse....that i think will clean up your engine, hehehe....that's what i just did.

To remove this ad, register today for free or log in if already registered!

[tom0826]

I have never done this, but I have a friend who is a ASE certified mechanic at a Ford dealership for over 10 years. We had a involved discussion about cleaning out the combustion chambers and I remember him saying that after the car is full warmed up, to get a spray bottle of water, and to spray into the intake as you rev the motor with the butterfly lever for about 5 minutes. This is supposed to essentially steam clean the combustion chambers. He then takes it for a 15 minute spin with hard accel and deccel over and over.

Again, I haven't tried this myself, but maybe some of you that know about this technique can elaborate...

[2K1Civic17"Gabe]

No matter where you get gas at, You will be getting deoderants (additives) in your gas. It is a legal standard, so you will always have some anyways. It helps to always fill up at the same place, preferably with a lot of business. I always go to Chevron to fill up. I added Techron when I was getting 20 miles to the gallon, and now I get about 30-40. If you fill up at cheap ghetto stations, there is a good chance you will get water in your gas, because they cheat the standards. I did a lot of reading on the internet on the best gas to use. chevron, exxon, i think shell were good

I know this is an old post, but Im bored

[ctx66]

Originally Posted by 2K1Civic17"Gabe

If you fill up at cheap ghetto stations, there is a good chance you will get water in your gas, because they cheat the standards.

http://theoildrop.server101.com/ubb/...c;f=5;t=002231

[zachgeyer]

no fuel system cleaner work