No idea what could this problem be.

hurley2301 · 01-13-2007

Recently got ym amp back after getting a bad ground inside the amp being fixed. Before i fixed the amp all the aireing worked fine. i got the new amp and went to install it, and it seems like there is no power going through the amp and into the subs. the power button does not turn on, but all the wireing is good. it was installed by professionals and hasnt been touched by me. coudl the fuse i have in the wire running form my battery be too small of a fuse? its 8 gauge wire and i got a new fuse for it because mine was lost when i took my amp out and disconnected the power cable.

To remove this ad, register today for free or log in if already registered!

hwt101 · 01-13-2007

if the fuse was to small it would blow, but if it was prof installed then you should take it back to them and have them look at it, it should be covered. Also you can have the amp bench tested to see if its working properly