Jdm d17 help with vtec
#1
Registered!!
Thread Starter
Join Date: Jan 2016
Age: 34
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Jdm d17 help with vtec
Ok so I Got a 1.7 d17 from Japan with the ecu all sensors are the same other then the vtec how do I make it work where do I hook up the vtec wire
#2
If you think a good mechanic is expensive, try hiring a bad one
Re: Jdm d17 help with vtec
Swap the original VTEC pressure switch into the new engine.
#3
Registered!!
Thread Starter
Join Date: Jan 2016
Age: 34
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: Jdm d17 help with vtec
So my civic is the 1.7 non vtec Jdm engine I got is vtec with the ecu do I just plug the Jdm ecu to my wiring harness and where do I hook up the vtec solenoid wire to
And another question can I run and drive my engine for a long time with out the vtec solenoid with out hurting the engine
And another question can I run and drive my engine for a long time with out the vtec solenoid with out hurting the engine
#4
If you think a good mechanic is expensive, try hiring a bad one
Re: Jdm d17 help with vtec
If using the original wire harness for a non-VTEC engine, now you will have to run a new wire to operate it...and you'll need a correct terminal/pigtail to install in the PCM connector for it.
Does this new engine use a knock sensor where the old engine did not?
Does this new engine use a knock sensor where the old engine did not?
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
dabatman99
Mechanical Problems/Vehicle Issues and Fix-it Forum
35
02-16-2016 07:11 PM
1hondacivic1
Archive - Parts for Sale
0
01-18-2016 10:06 PM
Niaboc67
Mechanical Problems/Vehicle Issues and Fix-it Forum
6
01-18-2016 06:25 PM