You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join civicforums.com today!
http://www.stylinconcepts.com/parts....tfamilyid=1549
there are tons, just go on google. and i would probably just buy the kit if it were me. the kits are waterproof and i'm sure best buy leds don't like water very much.
To remove this ad, register today for free or log in if already registered!
If you buy good LEDs you wont have to worry about that stuff. LEDs are in a plastic capsule to begin with, as long as you silicone around the bare wire and connections you will be fine, Ive done many LED projects on the outside of cars and as long as they are sealed properly you will not have any problems.
__________________ You know how life goes, sometimes your the bug, othertimes you the windshield...
ok I have seen both pics.....
and have to say I think the single would look better if done...any opinions?
and does anyone have a do it yourself? or is someone planning on doing it?
the custom 1 L.E.D pic:
and the kit L.E.D pic:
__________________ I reciprocate on Rep points!
---> new sig will go here <---
Quote:
Originally Posted by Nitto
Lets see your junk box, better yet, grab a line with mine sweetheart.
On the ignition key cylinder 1 of 2 plugs, Pin 5 = Wht/Blu / Pin 6 = Wht/Blk. This is the source for the lighted key cylinder lamp or LED used on the EX models. Strictly a low current source that mirrors the actions of the dome lamp (except when set to on or off)
haha if you're like me its rice style with the wires just hanging outside (I put loom at least). But the proper way is through the stock rubber boot. But good luck getting it through there, especially if your door is sealed with dynamat.
__________________
Restore Performance, Reduce Costs www.lubecontrol.com
Are you using the new soy based fp-plus?
________________________________________
Go Here For Real Medicine http://www.youngliving.com/
Member 1025782
________________________________________
Jobs wanted in boulder or louisville colorado.
PM me if you know companies that are hiring.
just do what i did? it doesn't look too bad with a bit hanging out. I just ran the wire under the door panel (didn't even have to remove the whole thing) and sticking out to go through the boot.
__________________
Restore Performance, Reduce Costs www.lubecontrol.com
Are you using the new soy based fp-plus?
________________________________________
Go Here For Real Medicine http://www.youngliving.com/
Member 1025782
________________________________________
Jobs wanted in boulder or louisville colorado.
PM me if you know companies that are hiring.
But the proper way is through the stock rubber boot. But good luck getting it through there, especially if your door is sealed with dynamat. 
