You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join civicforums.com today!
Hey everyone I have a huge dilemma, I purchased a Xenondepot 5000k High/Low H4 HID kit. I installed them and I dropped the bulb shattering into a million pieces, so then I go online looking for bulbs and I find the Supervision 6000k High/Low Beam bulbs, so I order them, now I am trying to install them and I don't know how...
I got them to work, but without high beams, which would take away from spending all that money on the dual beam kit...ok, the Supervision Bulb has four wires going to it...a green, blue, black, and red...from the Philips Ballast it has three wires...an orange, red, and black....
So when I wire the red and black they work fine, BUT I can't get the HIDs to work...anyone have any ideas on what to do with those last few wires? Any help would be greatly appreciated...thanks!
To remove this ad, register today for free or log in if already registered!
Sponsored Links
To avoid seeing this ad in our forum please register at CivicForums.com
By joining our free community you will have access to post topics, respond to polls, upload content and access many other special features.
, so then I go online looking for bulbs and I find the Supervision 6000k High/Low Beam bulbs, so I order them, now I am trying to install them and I don't know how...
